Conduits
Revit treats conduit like any other pipe. This panel doesn't.
Featured
Run a whole bundle of conduits between two points at once.
When you've got a stack of conduits leaving one spot and landing in another, doing them one at a time is a slog. Conduit Loom does the whole bundle in one go, using offsets or kick 90s across every run. Set it up once and it solves the lot.
More in this panel
Drop a clean offset between two parallel conduits.
Two parallel runs at different elevations, and you need them joined. Pick both and Conduit Offset builds the offset, solved right, landing where you put it, instead of nudging a fitting around until it looks close.
Join two perpendicular conduits with a clean kick 90.
Same idea as Offset, but for runs that meet at 90. Pick the two conduits and you get a proper kick 90 between them. No working out the geometry by hand, no gaps left in the model.
Hop a round obstruction with a clean 3-point saddle.
When a run has to get over something round in its path, another conduit or a pipe, a 3-point saddle rises up and over it. Pick the two parallel conduits and Nodal builds the saddle, solved and landed, instead of fitting it by hand.
Clear a wider obstruction with a flat-topped 4-point saddle.
Same idea as the 3-point, for wider obstructions: a 4-point saddle rises, runs flat across the top, and drops back down. Pick the two parallel conduits and it builds the whole thing.
Free on the Autodesk App Store. Nodal+ adds the heavier automation, with a 7-day trial.
